If you're on Facebook, scope out the 80% builders group. I don't know how they do it, but there's no shortage of people making trigger pockets that look like a squirrel chewed them out, and depending on how bad it is, it's either good to go or they're told to JB Weld it and re-do it. lol. Figure it this way though, if you completely botch a lower, it's only $40 or $50. Not a big deal. They really aren't hard to do though, so don't be intimidated.
Re-read my post and point to where I said anything about the last 6 months? If you're just buying lowers now, you're way behind the curve. Even OP has a bunch stashed away.
Really? I was watching a guide and the dude said it HAD to be within a few thousandths tolerance.
If you're on Facebook, scope out the 80% builders group. I don't know how they do it, but there's no shortage of people making trigger pockets that look like a squirrel chewed them out, and depending on how bad it is, it's either good to go or they're told to JB Weld it and re-do it. lol. Figure it this way though, if you completely botch a lower, it's only $40 or $50. Not a big deal. They really aren't hard to do though, so don't be intimidated.
lol
where have you seen an 80% lower for less than $100 in the last 6 months
Re-read my post and point to where I said anything about the last 6 months? If you're just buying lowers now, you're way behind the curve. Even OP has a bunch stashed away.