40
Comments (24)
sorted by:
You're viewing a single comment thread. View all comments, or full comment thread.
1
MAK90 1 point ago +1 / -0

I'm on a phone so hard to tell but looks like he tried to rack it before pulling the mag?

1
MAGA_VANGUARD 1 point ago +1 / -0

Here is what I saw

  • Thumb riding slide when trigger pulled
  • Round goes off, slide goes all the way back, then forward about half an inch
  • Not sure if he tried to pull trigger again, but saw trigger jerk when attempted
  • slaps magazine on bottom
  • pushed down on the slide release, does not actuate
  • pulls slide back, slide now locked
  • definitely bullet casing stuck in ejection port at this point
  • pushes down on mag release, swears, then rips the mag out
  • slide goes forward
  • new mag inserted, rack slide, good to go

Still a bit confused on the actual malfunction after the stuck casing. Anyone else wanna take a shot at it (pun intended).

2
FreedomFlowerDelta 2 points ago +2 / -0

Squib round, fail to eject. Slide after squib round doesn't blow back far enough. Casing jammed in ejection port preventing forward slide motion